------------------------------------
------ DCB Hardware validator ------
------------------------------------

* Testing MODEL:
 + Reading model from /etc/datik/config/dcb_model:
   - PASS: dcbh
* Testing MAC:
 + Reading MAC from /sys/class/net/eth0/address:
   - PASS: d0:63:b4:02:4c:d7
* Testing VERSION:
 + Reading version from /etc/datik/VERSION:
   - PASS: 3.8.1
* Testing CONFIGURATION:
 + Reading configuration from /etc/datik/config/sysconfig/done:
   - PASS: tuvisa (configured at 2025/03/20 12:52)
* Testing APC:
 + Checking APCs:
   - WARN: APC Version not supported. Connected APCs: 3/4, IN: 1, OUT: 1
Warning: Version not tested, connected to IP: 192.168.10.21:9006, , mainVersion: T200702.02, appVersion: T20070202, protocolVersion: 1.0.4, IN: 1, OUT: 1
Warning: Version not tested, connected to IP: 192.168.10.22:9006, , mainVersion: T200702.02, appVersion: T20070202, protocolVersion: 1.0.4, IN: 0, OUT: 0
Warning: Version not tested, connected to IP: 192.168.10.23:9006, , mainVersion: T200702.02, appVersion: T20070202, protocolVersion: 1.0.4, IN: 0, OUT: 0
Error: Not connected, configured IP: 192.168.10.24:9006
* Testing CONNECTIVITY:
 + Checking ping to DNS server:
   - PASS: Network is accessible.
* Testing NETWORK:
 + Checking network status:
   - PASS: All expected devices are detected.
* Testing CCTV:
 + Checking CCTV recorder:
   - ERROR: CCTV Taking too long to start. Something is not OK
* Testing GPS:
 + Connection with core-gnss:
   - PASS: 42.8649 N,-2.67497 W ; 2026-01-30 06:45:50 ; Satellites:9
* Starting CAN tests for: can2 can1
* Testing CAN can2 bus:
 + Launching traffic test on 'can2' :
   - ERROR: can2 is down.
* Testing CAN can1 bus:
 + Launching traffic test on 'can1' :
   - ERROR: can1 is down.
* Testing HDD:
 + Checking hard disk device:
   - PASS: HDD found.
* Testing SIGNS:
 + Checking SIGNS:
 + Connection with sae-destinationsigns:
   - PASS: Sign type is configured as none.
* Testing GPIO 1 status:

   - INFO: NONE state is:  ON and configured as INPUT
* Testing GPIO 2 status:

   - INFO: NONE state is:  ON and configured as INPUT
* Testing GPIO 3 status:

   - PASS: NONE state is:  OFF and configured as INPUT